2. Restore factory settings and switch wireless band:
The reset key is hidden in the RESET hole. It is able to work under power on status. To use one
long and narrow insulated stick (like toothpick) to insert the hole end to press the button as below:
2.1 Restore Factory Setting: To press the button for lasting three seconds, then the HDMI Status
Led Light will flash for three times and restart, it shows that Restore Factory Set is successful.
Note: You must to restore factory set at both transmitter and receiver.
2.2 Switch Wireless Band: Press the button to cyclic switch the 2.4G/5G (only for TX). The default
frequency is 5G.
3. Web settings:
To prevent the interference caused by the same frequency device, the Wireless HDMI Extender
support to set up the working frequency, transmit channel and SSID by the WEB. For safety, the user
should change the SSDI and the password at the first log in. Please follow the below steps:
3.1 Connect 5V power supplies to the TX&RX, and let them be connected.
3.2 Turn on the WLAN of the mobile phone / PC
，
search and connect SSID
：
Mini_HDMI_Wireless,
Enter the default password: 00000000
.
3.3 Modify the IP address type of the mobile phone / PC to Auto. When you select static type, you
must be set the IP in 192.168.1. xxx address segment range, e.g. 192.168.1.100.
3.4 Open the browser and scan the QR code or enter “192.168.1.10”
in the address bar to enter the configuration page.
.
As shown below:
