Rocker Switch:
Power switch (LED lights for power ON)
DC 5V:
5V DC in jack
LINK/ACT LED:
Network port status indicator LED
(lights off: link fail, Light on: link ok, flash: Link ok and TX/ RX activity)
RJ45x4:
10/100M Ethernet interface
AUDIO IN L/R:
Analog audio input (CVBS and S-video use the same Audio signal input channel)
CVBS IN:
Composite video signal input port
（
AV IN
）
SVIDEO IN:
S-Video signal input port
AUX IN:
Auxiliary audio input (this audio channel is used together with the VGA Video signal input)
VGA IN:
VGA input port
HDMI IN1/2/3:
HDMI input ports
HDMI OUT:
HDMI output port
OPTICAL OUT:
Optical/Toslink digital audio output
AUDIO OUT L/R:
L/R analog audio output ports
: Power ON/standby
SVIDEO:
Select SVIDEO for the input port
AV:
Select CVBS for the input port
VGA:
Select VGA for the input port
HDMI1/2/3:
Select HDMI 1/2/3 for the input port
:
Source selection key
2CH
：
2CH LPCM mode. Switch to 2CH mode for the HDMI
source to output LPCM 2 channels audio per the FIG.1.2 Remote Panel View
built-in EDID. Then HDMI, OPTICAL, AUDIO output stereo audio.
5.1CH
：
5.1CH bitstream Mode. Switch to B5.1CH mode for the HDMI source to output bitstream
audio per the built-in EDID. Then HDMI, OPTICAL output 5.1CH audio, AUDIO not output.
ADV
：
HDMI pass mode. Switch to PASS mode for the HDMI source to output audio per the EDID of
connected TV or AV receiver, supports up to LPCM 7.1 channels.
:
Sound Output mute
(HDMI/SPDIF/AUDIO output mute when Press this button, Press again for unmute)
(Note: Use after the battery separator film is pulled out)