www.asiarf.com
TEL: +886-2-29407880
FAX: +886-2-29407800
1F, 7, Houde Street, Younghe District, New Taipei City, Taiwan, R.O.C
10
5150-5850MHz
2400-2483.5MH
z;
5150-5850MHz
ANT003
PCB
2.4GHz: 2.5
5GHz: 2.5
0.3dBi
2400-2483.5MH
z;
5150-5850MHz
A245005N
PCB
2.4GHz: 4
5GHz: 5.1
0.3dBi
2400-2483.5MH
z
A2405N
PCB
2.4GHz: 5.2
0.3dBi
5150-5850MHz
A5005N
PCB
5GHz: 5
0.3dBi
2400-2483.5MH
z;
5150-5850MHz
A245004
Dipole
2.4GHz: 4
5GHz: 5.1
0.3dBi
2400-2483.5MH
z;
5150-5850MHz
A245002
Dipole
2.4GHz: 2
5GHz: 2
0.3dBi
4. Label and compliance information
Label of the end product:
FCC
The host product must be labeled in a visible area with the following " Contains FCC ID:
TKZAW7915NP1".
The end product shall bear the following 15.19 statement: This device complies with part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
ISED
This transmitter module is authorized only for use in device where the antenna may be installed such
that
20
cm may be maintained between the antenna and users. The final end product must be labeled
in a visible area with the following: “Contains transmitter module IC: 9968A-AW7915NP1” or
“Contains IC: 9968A-AW7915NP1”
Contient le module d'émission IC:
9968A-AW7915NP1
The Host Model Number (HMN) must be indicated at any location on the exterior of the end product
or product packaging or product literature which shall be available with the end product or online.
5. Information on test modes and additional testing requirements
This module has been approved under stand-alone configuration.
OEM integrator has be limited the operation channels in channel 1-11 for 2.4GHz band.
The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093/RSS-102 and different antenna configurations.
The information on how to configure test modes for host product evaluation for different operational
conditions for a stand-alone modular transmitter in a host, versus with multiple, simultaneously
transmitting modules or other transmitters in a host can be found at KDB Publication 996369 D04.
OEM integrator is still responsible for testing their end product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC/ISED authorization is no longer
considered valid and the FCC/IC No. cannot be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC/ISED authorization.
