ALPACO ELEGANCE INSTALLATION
Page 4
STEP 5:
FIGURE 5
SECURING PILASTERS TO PANELS
A. A 6” (or 9” if required) support is recommended to
place under each pilaster to assist in alignment.
B. Plumb each pilaster and fasten the pilaster to the panel
with U-brackets using through-bolts through the
panel.
C. Establish door openings as measured from the inner
edge of one pilaster to the inner edge of the other
pilaster.
D. Mark and drill floor and panel for each pedestal.
Attach pedestal to the floor and the panel.
E. Remove the support device.
STEP 6:
FIGURE 6
HEAD RAIL
A. Plumb each pilaster.
B. Verify door openings between
pilasters prior to drilling holes
in headrail (holes for headrail
clips and couplers are
predrilled at the factory).
C. Attach the head rail (see figure
for head rail connections).
Tube should be seated fully
into the connectors and
drilled to accept fasteners
using a #25 drill bit.
160 Tower Drive
, Burr Ridge,
IL 6052
7
Phone: (708) 442-6800 Fax: (708) 442-7439
www.asi-accuratepartitions.com
