Operator Manual – MQX-2310 Equalizer
Page - 7
All Rights Reserved
Installation
Use four screws and washers when rack mounting the Equalizer. For mobile use, the unit
should be further secured as appropriate.
General Requirements
MQX Equalizers have specific physical, electrical and signal requirements for proper
operation. These requirements will vary depending on your specific application, setup, and
the settings on the Equalizer. When setting up and testing your system, please take special
care to double check all connections and settings. Please refer to the specifications section
of this manual for specific input, output and other figures.
AC Power
Your MQX equalizer should be connected to a standard 3-wire grounded electrical outlet
supplying 100-240 Volts, 50-60 Hz. To reduce the risk of ground loop hum, connect all
audio equipment to the same electrical power source. Do not remove the AC plug ground
pin, as a potential shock hazard could result.
This unit will perform normally within the AC voltage range specified above. Voltages
less than this, as found in “brown-out” conditions, may reduce performance. No user
serviceable parts are inside the chassis. Refer all servicing to qualified service personnel.
Overall power consumption is less than 30 watts.
NOTE
: The power switch does NOT isolate the appliance from mains. Make sure the mains
power socket or an alternative disconnect device is near by and easily accessible. When the
product is connected to mains, the line-filter and the input of the fuse are energized.
Introduction - 4
MQX Equalizers – 5
Connectors & Cables – 5
Physical Description - 6
Installation – 7
General Requirements
AC Power
Typical Applications - 8
Troubleshooting - 9
Dimensions - 9
Specifications - 10
Warranty - 10