Ashly GQX-3102 Скачать руководство пользователя страница 9

Operator Manual – GQX-3102 Equalizer 

 

Page - 9 

 

All Rights Reserved 

Troubleshooting 

Situation 

Action  

No Audio Output 
 

Check AC power - is the power LED on? 
Check in/out connections - are they reversed? 
Are you sure you have an input signal? 

EQ Controls Do Nothing 

Is the master EQ switch in? 
The lowest and highest frequency sliders may be beyond the range of the program material 
or speakers and may produce little or no audible effect.  

Peak Light Flashes or 
Stays On All the Time 
 

If the peak light flashes, the signal level to the equalizer is too high. Turn down the gain. If it 
is on all the time, disconnect the input and output cables. If it is still on, the unit must be 
returned for service.  

Distorted Sound 
 

This will only be caused by too much signal which will show on the Clip LED. If the LED is 
not flashing, there is an overload somewhere else in the signal path. Adjust the relative gain 
of each component in your chain to keep everything at a comfortable level. 
 

Excessive Hum or Noise 
 

Hum will usually be caused by a ground loop between components. Try using the suggested 
balanced input and output hook-ups if the other pieces of equipment used in conjunction with 
your equalizer have balanced inputs and outputs. Noise (excessive hiss) can be caused by 
insufficient drive signal. Make sure you are sending a nominal 0 dBu line level signal to the 
equalizer.  Most noise problems occur because gain is applied to audio signals too late in the 
chain. For best performance, apply gain to individual source signals as early as possible, like 
at the mixer input section. As gain increases, it also boosts the noise content of that signal. 
Any cumulative noise built up in a mixed signal will only be increased by using an equalizer 
as a gain device, so make every attempt to operate the equalizer with as little gain as 
possible. 

 

Note: Unshielded cables, improperly wired connections, and cable with broken strands 
(shorts, etc.) are the most common problems. Use good quality cable with connectors 
soldered firmly on the correct pin. When in doubt, get in touch with your Ashly dealer. 

Dimensions 

Introduction - 4 

GQX Equalizers – 5 

Connectors & Cables – 5 

Physical Description - 6 

Installation – 7 

Typical Applications - 8 

Troubleshooting - 9 

Dimensions - 9 

Specifications - 10 

Warranty - 11 

 

Содержание GQX-3102













Отзывы: