Page 7 of 43
P015-913
A self contained LP-gas cylinder for use with this appliance must have a
capacity of 20 lbs. and must be equipped with a Type 1 connector and an
OP D (overfill protection device). See Figure 1.
The LP-gas supply cylinder to be used must be constructed and marked in
accordance with the specification for LP- gas cylinders of the U.S.
Department of Transportation (DOT) or the National Standard of Canada,
CAN/CSA-B339, Cylinder, Sphere and Tubes for the Transportation of
Dangerous Goods
.
The cylinder supply system must be arranged for vapor withdrawal.
The cylinder used must include a collar to protect the cylinder valve.
This appliance shall be used only outdoors in a well-ventilated space
and shall not be used in a building, garage or any other enclosed space.
When this appliance is not is use, the gas must be turned off at
the supply cylinder.
Storage of this appliance indoors is permissible only if the
cylinder is disconnected and removed from the appliance.
Cylinders must be stored outdoors in a well-ventilated area out of
the reach of children .Disconnected cylinders must have threaded valve
plugs tightly installed and must not be stored in a building, garage or any
other enclosed areas.Storing cylinders indoors or in poorly ventilated spaces
outdoors can result in serious bodily injury and/or death.
CSA (Canadian Standards Association) certified to ANSI
Z21.97•CSA
2.41-2016
“ Outdoor Decorative Gas Appliances”.
Figure 1
SPECIFICATIONS
INPUT
40,000 Btu/hr
Propane Regulator
Pressure
11 inches water column
Natural Gas Minimum
Inlet Pressure
7 inches water column
Clearances to
combustible surfaces
Sides: 48in./121.9cm
Top: 72 in. / 182.9 cm
IMPORTANT SAFETY INFORMATION ABOUT
PROPANE (LP) GAS