4.
Sit at the loom and adjust the angle of the loom until it is
resting on your knees and the angle of the footrest to suit and
tighten the knobs.
5.
Store the Hex Key in a safe place and retighten the bolts if
required.
6.
Note - Support braces are optional accessories for the
SampleIt Loom Stand.
Enjoy weaving on your SampleIt Loom!
1.
If your loom is 25cm (10”) wide, use the short footrest, if
your loom is 40cm (16”) wide, use the long footrest.
2.
Attach the appropriate footrest to one leg and foot as
illustrated with a 50mm (2”) bolt and barrel nut and lightly
tighten with the Hex Key. Note the tapered leg fits snuggly into
the tapered rebate in the foot. Repeat for the other side. Store
the spare rail for future use.
3.
Insert the 40mm (1 ½”) round head bolts from the inside of
your loom and tap the head of the bolts flush against the loom
side. Then locate the loom and bolts into the slots in the legs
and secure with washers and knobs.
Foot
Leg
Foot
Leg
Barrel nut
Footrest
Fo
ot
Le
g
40mm(1½”) bolt
Washer
50mm (2”) bolt
Knob
Footrest
Foot
Leg
Ashford Handicrafts Limited
415 West Street, P O Box 474, Ashburton, New Zealand
+64 3 308 9087
[email protected]
www.ashford.co.nz
ASSEMBLY INSTRUCTIONS
