8
Back Rail M
Lever Assembly N
M8 x 25 Washers
N
N
N
N
N
N
N
N
M
H
M6 x 80
Hex Head
Bolt
M6 x 16
Washer
M6 Barrel
Nut
M6 Barrel
Nut
6. Apply a drop of oil onto the two lower steel rods. Then slide 5 x M8 x 25
washers
onto the two lower steel rods followed
by a lever assembly
N
. Place two washers onto each lower steel rod followed by another lever assembly
N
. Repeat this
procedure until all the lever assemblies are in position, finishing with 5 washers.
7. Locate the second rail
M
onto the steel rods and secure to blocks
O
using two
8 x 2 Screws at each end
.
8. Identify the cloth beam supports
F
(left) and
FX
(right).
FX
has a counter-bored hole on the outside.
9. Attach
but do not
tighten
FX
to
DX
with a
M6 x 80 Hex Head Bolt
,
M6 X 16 Washer
and
M6 Barrel Nut
and attach to
EX
with the
M6 x
180 Threaded Rod with Dome Nut and M6 X 16 Washer
. Repeat for the opposite side with
F
,
D
and
E
. Keeping the nylon bushes to
the inside.
Note:
The nylon bushes are towards the rear.
10. Slide the ratchet lever
G
onto the steel shaft on the cloth beam
H
and ensure the pawl engages the ratchet teeth.
11. Twist the cloth beam support
FX
up slightly and locate the cloth beam
H
into the nylon bush. Lower
H
so the holes in
H
and
F
line up and then carefully tap a
5/8 x 75 Steel Shaft
through the nylon bush and into
H
. Then tighten the bolts securing
F
and
FX
.
M6 x 16
Washer
M6 x 180 Threaded Rod
and Dome Nut
Содержание Jack Loom
Страница 5: ...5 PARTS...
