ASG, Division of Jergens, Inc.
15700
S. Waterloo Road | Cleveland, OH 44110-3898 | Phone: (888) 486-6163 | Fax: (216) 481-4519 | Email: [email protected] | Web: www.asg-jergens.com | Revision: 8/24/2020 | Page 3 of 3
TLB-C Brushless Electric Screwdrivers
Operation Manual
Torque Adjustment Operation
• Determine the torque output of the tool by checking a tightened fastener with a torque
tester such as the ASG DTT or DTT-L.
• Increase or decrease the torque by rotating the Spring Adjusting Ring. Rotating the ring
clockwise to a higher number on the torque scale increases torque output while rotating
the ring counterclockwise to a lower number decreases the torque output.
• Continue to check the adjustment with a torque tester until you are satisfied with
the torque output. If you are making final torque adjustments on line, always start
below the desired torque and work upward.
• The torque scale on the tool goes from 0 to 8. Only the even numbers appear: 2,4,6,
and 8. This is not the actual torque the tool is going to produce. The numbers on the
scale are only a point of reference.
Servicing
Maintenance and Inspection
• Do not use the tool more than 8 hours a day.
• Do not let the motor and power supply get over heated. Do not run more than
10-15 screws/minute.
• If you use the tool more than 8 hours a day, have the tool evaluated for
preventative maintenance.
• Inspect tool cords periodically. If damaged, contact ASG.
• Do not remove any labels.
Using non-ASG replacement parts may result in decreased
tool performance and increased maintenance and may void all
warranties.
All repairs and maintenance of this tool must be performed by ASG
ASG is not responsible for customer modification of tools for
applications on which ASG was not consulted.
It is the responsibility of the employer to place the information in
this manual into the hands of the operator.
Servicing (Continued)
DO NOT ATTEMPT TO REPAIR THIS ELECTRIC SCREWDRIVER
SAVE THESE INSTRUCTIONS - DO NOT DISCARD
Warranty
The warranty is 1 year after delivery. If any troubles should occur, please contact ASG.
In the following cases, the purchaser shall pay for parts and labor regardless of the
terms of warranty:
• Failure due to improper handling.
• Failure due to product modification or improper processing.
• Failure due to causes beyond control (for example earthquake or fire).
• Consumables, replaceable parts, and replacement work expenses.
PLEASE NOTE: When repairing or replacing tools or components on any TLB
Series purchased in 2016 or prior, please contact ASG representative