ASG, Division of Jergens, Inc.
15700
S. Waterloo Road | Cleveland, OH 44110-3898
Phone: (888) 486-6163 | Fax: (216) 481-4519
Email: [email protected] | Web: www.asg-jergens.com
Page 2 of 3
PS-55AT
User Manual
Backboard
Power Supply Signal Time Scale
© 2017 Jergens, Inc. All Rights Reserved | Revision Date: 2/23/2017
Output/Input Signal
Terminal:
controls
start and stop of
electric driver, and
clutch output signal
Power Cord Socket
Fuse Jack, 2A/110V or 1A/230V
Input Voltage
Selection Switch:
providing choice of
110V/230V
T1
Turn on the power and start the power supply at least 2 seconds after the power is off (Robotic Operation)
T2
Input the signal to start the electric driver at least 2 seconds after the power supply is started (Robotic Operation)
T3
Indicating the start signal of the electric driver, which shall exceed 0.5 second
T4
Indicating the run time of the electric driver, which varies with the locking time
T5
The clutch signal of the electric driver
T6
Signal output by the backboard (Finish) of the power supply when the clutch operates, lasting for a period from the time when the clutch activates until the
input of Stop signal
T7
Indicating the stop signal (required to be longer than 0.5 second), which is explained as follows:
•
If the electric driver is running, input of this signal may stop the electric driver before a clutch signal is seen
•
If the clutch activates, the signal may open Finish output (Open)
•
When the Start signal exists, Stop signal will not be accepted. A minimum interval of 0.5 second is required between the two signals
T8
The interval between the stop signal and start signal should be longer than 0.5 second
