7
Configuration
The product needs to be configured with basic settings. Some products settings
can be set in an installation Setup Wizard accessible from the web interface. The
Setup Wizard will start automatically the first time the module is accessed from
the web browser and every time until the configuration has been saved.
If the product has not got a Setup Wizard all settings are set from the products
configuration pages, see
Setup from the Advanced Configuration Page
Note:
For extended configuration, refer to the Installation and Operation
Manual for this product.
Setup via the Setup Wizard
1 Access the module either via the network or via the management port.
2 Enter user name “admin” and the password “changeme”.
3 Complete the Setup Wizard.
(If the module’s network IP address has not been assigned by a DHCP server, it
must be set manually in the wizard).
4 Select “Restart now” when the setup wizard has finished.
The module will restart with the new configuration.
Setup from the Advanced Configuration Page
1 Access the module either via the network or via the management port, but add
“/admin” after the address in the address bar as in “xxx.xxx.xxx.xxx/admin”,
where xxx.xxx.xxx.xxx is the modules IP address.
2 Enter user name “admin” and the password “changeme”.
3 Click “System Setup” and navigate to “Network”.
4 Set the network parameters. Use the on-line help if any problems occur.
5 Click “License” and enter the license number.
6 Click “Settings” and select time source.
7 Change the default passwords for all users.
If the passwords are not changed, anyone with knowledge of the default
passwords can access the module and change any parameter.
8 Reboot the module by navigating to “Reboot”.
9 When the module has been restarted, enter “xxx.xxx.xxx.xxx/admin” in your
browser (xxx.xxx.xxx.xxx is the IP address that was given to the module during
network setup) to see that it has started up correctly.