ASCHER RACING F64-USB, Руководство по эксплуатации продукта

Страница: 11 / 15

1. Reset All : reset all settings to factory default
2. Analog Input Mode
•
Throttle and Brake: two separate axis for both clutches
• Dual Clutch: one single axis for both clutches, both signals are compared and whichever signal is greater will be the output
3. Master Clutch
• set which clutch is the master clutch
•
master clutch will not be affected by clutch bite point setting
•
slave clutch is scaled down so that 100% mechanical throw equals clutch bite point
4. Clutch Bite Point : set the value of slave clutch at 100% mechanical throw
5. Rotary Switch Mode :
•
12 Way Rotary: constant button press of the rotary switch
•
12 Way Rotary Pulsed: pulsed button press of the rotary switch
•
Encoder: pulsed button for each clockwise and anti-clockwise rotation
•
Shift Encoder: one rotary switch acts as selector, the other one as encoder -> use 12 encoders for various settings this way
6. Encoder Pulse Width : set the duration of button presses of encoders
7. LED Intensity : adjust intensity of the bite point calibration mode signal LED
8. Inputs : shows all available inputs (must not show every single encoder step due to update cycle)
9. X-Axis/ Y-Axis : output of left/ right clutch
•
linearity modes: linear, progressive/ degressive, S-Curve
•
dead zones: adjust buffer between electrical and mechanical throw, LOW = start/ HIGH = end
10. Calibrate :
1. set Analog Input Mode to Throtte and Brake
2. release clutch and click Set Low
3. pull clutch fully and click Set High
4. configuration tool
11