ASCENTO GROUP AUSTRALIA P: 1800 807 604 F: 1800 807 609 E: [email protected]
DANGER!
ALWAYS DISCONNECT
THE PUMP FROM POWER
WHEN INSTALLING, AND
WHILE SERVICING OR
REPAIRING.
IMPORTANT!
ALWAYS PRIME THE
PUMP BEFORE STARTING.
TIP!
SOMETIMES YOU MAY
HAVE TO DO THIS AFTER THE
PUMP HAS STOPPED DUE TO A
RUN-DRY EVENT
© Ascento Group Australia, 2016
DIAGRAM 10
DIAGRAM 11
DANGER!
ENSURE THE PUMP IS
CONNECTED TO A
DEDICATED POWER OUTLET
THAT IS PROTECTED BY A
SAFETY SWITCH (RCD)
HAVING A RATED RESIDUAL
OPERATING CURRENT NOT
EXCEEDING 30mA.
TIP!
IF YOUR
PUMP STOPS,
CHECK YOUR
TANK, IT MAY
BE EMPTY.
IMPORTANT
FOR VERY LONG SUCTION/INTAKE PIPEWORK, IT IS CRITICAL THAT THE CORRECT PIPE SIZE IS USED AND THE PIPE
IS FALLING ALL THE WAY TO THE PUMP. CHECK WITH A QUALIFIED PUMP TECHNICIAN FOR THIS TYPE OF INSTALLATION.
INCORRECT!
PIPES TOO SMALL!
!
WRONG!
DIAGRAM 9
WRONG!
MODEL
INLET INLET PIPE
ID
OUTLET DISCHARGE
PIPE ID
VSRM38-72 25BSP 25 - 32mm
25BSP
20 - 25mm
VSRM48-72 25BSP 25 - 32mm
25BSP
20 - 25mm
VSRM39-102 32BSP 32 - 40mm
25BSP
25 - 32mm
VSRM58-102 32BSP 32 - 40mm
25BSP
25 - 32mm
VSRM50-270 40BSP 40 - 50mm 40BSP 32 - 40mm
The larger size is recommended for best performance. Pipe
sizes are Internal Diameter. We do not recommend 18mm
copper piping for these pumps.
1.
Connect it to the water supply, ensuring you
use the correct valves as per Diagram 1
2. Remove the bleed plug off the front of the
pump as indicated in the diagram (above
the water inlet, as indicated)
3. Open the ballvalve between the tank and the
pump to allow the water to come through
4. Wait until the water spills out the bleed hole
then re-fit the plug
5. Start the pump - if the failure light flashes,
repeat the process until it works.
To prime the pump - this is to fill it with
water so it will start:
BLEED PLUG
