AON126S CATV and SAT-IF Receiver
Solutions Provider for FTTx, RFoG, and HFC
www.ascentcomtec.com
Page 4 of 13
Warning
Exposure to class 1M laser radiation is possible. Access should be restricted to trained
personnel only. Do not view exposed fiber or connector ends when handling optical
equipment.
Ensure adequate cooling and ventilation as specified.
The installation and operation manual should be read and understood before units are
put into use.
Always replace protective caps on optical connectors when not in use.
The typical connectors fitted are SC/APC 8°.
Note:
8° angle polished connectors must be
used.
Cleaning
Use only a damp cloth for cleaning the front panel. Use a soft dry cloth to clean the top of the
unit.
Do not use spray cleaner of any kind.
Overloading
Overloading wall outlets and extension cords can result in a risk of fire or electric shock.
Use approved electrical cords.
Damage requiring service
Unplug unit and refer servicing only to Ascent Communication Technology qualified service
personnel.
Servicing
Do not attempt to service this unit yourself. Refer all servicing only to Ascent Communication
Technology qualified service personnel.
General Reminders and Warnings
Review these reminders and warnings before you inspect and clean your fiber-optic
connections.
Reminders
Always turn off any laser sources before you inspect fiber connectors, optical
components, or bulkheads.
Always make sure that the cable is disconnected at both ends and that the card or
pluggable receiver is removed from the chassis.
Always wear the appropriate safety glasses when required in your area. Be sure that
any laser safety glasses meet federal and state regulations and are matched to the
lasers used within your environment.
Always inspect the connectors or adapters before you clean.
Always inspect and clean the connectors before you make a connection.
Always use the connector housing to plug or unplug a fiber.
Always keep a protective cap on unplugged fiber connectors.
