Configuring Link Type
Use the following interface mode command to configure port link-type:
Switch(config)#
interface eth1
Switch(config-if-eth1)#
spanning-tree link-type
{
point-to-point
|
shared
}
By default, the link type is determined from the duplex mode of the interface: a full-duplex port is considered to have a
point-to-point connection; a half-duplex port is considered to have a shared connection.
To return the switch to its default setting, use the
no spanning-tree link-type
interface configuration command.
Configuring an Edge Port
Use the following interface mode command to configure port link type:
Switch(config)#
interface eth1
Switch(config-if-eth1)#
spanning-tree edge-port
The default setting is no edge port configuration.
To return the switch to its default setting, use the
no spanning-tree edge-port
interface configuration command.
Configuring Port Path Cost
Use the following interface mode command to configure port path cost:
Switch(config)#
interface eth1
Switch(config-if-eth1)#
spanning-tree path-cost
<
path-cost
>
The default values for path cost is determined by the operating port speed:
•
For ports operating in 1000Mb speed, the path cost is 20000
•
For ports operating in 100Mb speed, the path cost is 200000
•
For ports operating in 10Mb speed, the path cost is 2000000
To return the switch to its default setting, use the
no spanning-tree path-cost
interface configuration command.
Configuring Port Priority
Use the following interface mode command to configure port priority:
Switch(config)#
interface eth1
Switch(config-if-eth1)#
spanning-tree port-priority
<
port-priority
>
For <
port-priority>
, the range is 0–240 in increments of 16; the default is 128. The lower the number, the higher the
priority.
To return the switch to its default setting, use the
no spanning-tree port-priority
interface configuration command.
50
Asante IntraCore IC36240
User’s Manual
