Asante FriendlyNET FX4000, Руководство пользователя, Страница: 10 / 16

Asanté FriendlyNET FX4000 10
FX40-1T Gigabit Module
When installed into a switch, the FX40-1T Gigabit module provides one Gigabit Ethernet port that can
connect the switch to a Gigabit backbone switch or to a server with a Gigabit NIC adapter card.
The module comes with a 10/100/1000 Mbps Nway autonegotiating RJ45 connector with automatic MDI
crossover function which provides the link to the switch. There are four LEDs to indicate the status of the
module: LK1000 (Green at 1000 Mbps), ACT (Blinking Green with Activity), LK100 (Green at 100 Mbps)
and FD (Yellow at Full Duplex),
Installing the FX40 Optional Modules
You can purchase any or all of the optional modules separately to meet the needs of your network. The
process of installing optional modules is described below.
Follow these steps to install the optional module:
1. Power the switch OFF and disconnect it from the main power supply. The modules are NOT hot-
swappable
2. Place the switch on a flat surface. Grasp the thumbscrew on the sides of the optional module or
blank bracket and turn counter-clockwise to unscrew them. You can also use a screwdriver.
Remove the old module or the blank bracket and set aside. Do not discard the module or blank
bracket. Put the module or blank bracket back in if you remove the new module.
3. Install the new module by inserting it into the guides and sliding it in until it stops. Press it firmly
until you feel the module snap into place. Never force, twist or bend the optional module. The
optional module slides in smoothly.
4. Gently push the thumbscrews in and turn clockwise to tighten. Do not over tighten the
thumbscrews.
5. Power the switch on after you have installed the new module. The switch will auto detect the new
module.
6. Take off the dust cover from the transceiver and plug the cable in, if you are installing a fiber optic
or gigabit module.
7. Check the LEDs to verify that there is a link and a proper connection at the port.
Important ! Follow the instructions below on handling the modules to prevent damage:
1. Do not remove the module from its packaging until you are ready to install it into the switch.
2. Do not touch any of the components on the module other than the DIP switch, if applicable.
3. Touch the module only by its edges and front panel.
4. Always wear anti-static wristband connected to a suitable grounding point.
5. Always store or transport the module(s) in the appropriate anti-static packaging.