Step 6
Mounting instruction for Smoke Detector
WiFi set up for Asante Genie (Optional)
1. Remove the mounting base from the Smoke Detector (counter clockwise) and hold it against
the ceiling surface that you would like to install the unit.
2. Mark the screw holes using a pen or pencil as shown below and
Tighten the base to the surface using the screws provided.
3. Holding the smoke detector firmly into base, turn it clockwise to lock
4. You can also do the Location Test one more time to confirm the correct location for Smoke Detector.
Asante Genie wireless bridge mode can extend your wireless coverage in a large size property. For areas
larger than 5000 sq.ft, consider placing the Asante Genie in a
central location
to bridge Asante devices into
your home router. Otherwise we strongly recommend using the Ethernet wired mode. If you still want to use
the wireless option, please follow the procedure below.
1. Login to app and select the settings button as shown below
2. Select WiFi manager
3. Select your home router from the list
4. Enter your personal wireless password that has been setup on your router when prompted
Once connected, you can disconnect the Ethernet cable between the Asante Genie and router and move
the Asante Genie to appropriate location. The lights on the Asante Genie will indicate a wireless signal.
Testing Your Smoke Detector
Test the Smoke Detector weekly by pressing the test button and holding it for around 4 seconds until the
alarm sounds. The sound pattern is 3 beeps, pause, and then 3 beeps with red LED flashing continuously
and rapidly.
Step 7
Test Button and LED Light
In Standby Mode
The red LED, as the ALARM indicator, are featured with the Asante Smoke Detector Alarm.
It can be seen through the clear test button on the cover of the unit. When red LED flashes every 334 seconds,
it indicates that the Smoke Detector is under normal operation. When Smoke Detector senses smoke; it
sounds an alarm with 3 beeps, pause and 3 beeps. The red LED will flash continuously and rapidly.
Silence Feature
The silence feature can temporarily turn off sound for up to 10 minutes.
To use this feature, press test button on the cover when alarm goes off.
If the smoke concentration around the Smoke Detector is still at an alarming level after 10 minutes of silence,
the unit will re-alarm immediately.
Low Battery Warning Signal
If the alarm horn begins to chirp once in 43 seconds with red and yellow LED flashing, it indicates that the
Smoke Detector battery is weak. This low battery warning signal should last for up to 30 days. However, you
should replace battery immediately upon receiving this signal for continuous protection.
Tamper Switch Feature
If the Smoke Detector is not mounted into the bracket properly during the first 5 minutes after battery is
installed, the tamper function is triggered and the yellow LED stays on.
If the Smoke Detector is still not mounted into the bracket properly 5 minutes after battery is installed, you
will hear three beeps with yellow LED steadily on until smoke alarm is mounted back into bracket.
Internet
Wireless Router
Asante Genie
Irrigation
Controller
Garage Door
Opener
with Camera
Smoke
Detector
40
ft
5000 sq.ft
Use wireless connection to maximize
the WiFi coverage. Asante Genie can cover up to 5000 sq.ft
Radius
