Asada Beaver 4Eco, Инструкция по эксплуатации

Страница: 13 / 28

13
2.INSTALLATION
1)Carrying the Machine
2)Installation
-Always ground the machine to avoid electric shock or resultant death.
-Do not touch the plug with wet hands.
-Do not expose the machine to rain and water and do not use it in damp or wet
locations.Humidity will deteriorate motor insulation or lead to electric shock.
-Immediately replace Power Plug, Power Cord or extension cord, if damaged.
-An extension cord used should be a three-core cabtyre cable having an earth wire.
Use a thick and durable cord for outdoor use.
*1 Confirmation of Earth (Grounding) and Earth Leakage Circuit Breaker
(1)Put the machine in a place free from moisture.
(2)Put the machine on a flat surface without play or on a flat work bench.
(3)Secure a sufficient space around the machine. A wide space is necessary particularly when working long
and heavy pipe.
(4)It is mandatory to use the Pipe Support for long and heavy pipe. Avoid excessive force applied to the
machine which causes it to tilt.
(5)Make sure that the power source is equipped with a ground fault circuit breaker to avoid electric shock.
(6)Use an earth clip when a power receptacle without a base for grounding is used.(*1)
(7)When an extension cord is used, use the one conforming to the applicable regulations.(*2)
-Never install an earth wire to the gas pipe.If attempted, explosion may take place.
-Do not use the machine in the presence of flammable liquids or gases such as
gasoline and thinner. Otherwise, ignition or explosion may take place.
Before starting use of the machine, make sure that the power supply to which this machine will be connected is
fitted with an earth leakage circuit breaker for prevention of electric shock (earth leakage circuit breaker) which
conforms to the occupational safety and health law, electrical equipment technical standard, etc.
Always ground this machine. It is recommended to ground the machine for your
own safety if it is used with a power supply which is fitted with a current-operated
earth leakage circuit breaker having the rated sensitivity current of 15 milliam-
peres (mA) max. and the operating time of 0.1 seconds max.
When the receptacle used does not have a ground slot, the earth clip and earth
(ground) wire, confirm that they are without fault.
When you have a tester or an insulation resistance meter, check for continuity between the earth clip and the
machine’s metal frame. Grounding work (for example, burying the earth pole (earth plate, earth bar)in the
ground and connecting the earth (ground) wire) must be done by a qualified electrician.
*2 Extension Cord
When an extension cord is required for use with a distant power supply, is should be thick enough to carry a
current and as possible to ensure that the product is used with the maximum efficiency without a failure.
The extension cord used must be a three-cord cabtyre cable having one earth (grounding) core.
Noise Prevention Control
Noise is controlled as set forth in relevant regulations. The machine must be oper-
ated at less than the control value to avoid discomfort to the neighborhood.
Sound barriers may be required under some circumstances.
*3 Proper working environment
The working area should be put in order following the clauses in "OPERATING INSTRUCTIONS".