ROVE SETUP
1. Connec t the adaptor power cable with the charging base, a n d
then p l a c e any excess c a b l e into the c h a r g i n g b a s e ’ s i n n e r
compartment.
2. P lac e the charging b a s e agains t the wall on a flat surface.
Then connect the base to a power supply.
Don’t place charging base where it iwill be directly exposed to sunlight.
Note:
Ensure that the charging base has at least 0.5 m of free s pac e on
both sides, and 1.5 m of free s pac e in front of it.
During installation, keep the power cable off the ground. When the
power cable is on the ground, it may be dragged by the robot, which
will cause the charging base to power off.
The charging indicator light will remain on as long as t he charging
base has power.
3. Install the Side Brushes
Align the left and right brushes with the corresponding
markings on the bottom cover of the device. Press side
brushes down until they click
.
4. Power On a n d Charging
Press and hold the
button to turn on the device. Wait
until the indicator light turns on, and then place the device
on the charging base.
Note:
This device cannot start if it does not have enough power. Place
the device on the charging base, and it will automatically turn on
when it has enough power. The device can work normally only
when the battery is
≥20%
charged. As shown in the figure above,
the front of the device should face the charging base so that the
charging contact of the robot is touching the wireless power
receiver. The distance between the front of the device and the
charging base should be around 2 cm.
ROVE
8
