20
Notice:
You can find on the market ready
mixed two-stroke fuels. Based on our experi-
ence, the ready mixed fuels “STIHL Motomix
1:50”, “ASPEN 2-stroke” and “Oest Oecomix”
can be used. No guarantee can be given for
operation of the device with other fuels and
oils!
Do not use mixtures with more oil than 1:50
(e.g. 1:35).
Too much oil results in carbon deposits and re-
duces the service life of the engine.
Only use the fully synthetic two-stroke oils ex-
plicitly intended for mixing.
Use of engine oils or even waste oil results in
engine damage.
No warranty is given in these cases.
Storing fuel mixture
The fuel mixture ages and can cause engine
damages. Only mix as much fuel as you are
going to use up during the next mowing.
Fuel used (4-stroke devices)
As fuel, use unleaded petrol (see operating in-
structions of the engine manufacturer).
You can use E10 petrol. Do not store E10 pet-
rol longer than 30 days.
Check engine oil level
(4-stroke devices)
Attention!
Prior to each use, check the engine
oil level (see operating instructions of the en-
gine manufacturer).
To ensure sufficient oil supply for the four
stroke engine and to avoid resulting engine
damage, the device may only be used on
slopes up to 20°.
Tanking up
Warning
Fuel is ignited by hot engine parts.
► Prior to filling up, switch off the engine
and wait for at least 20 minutes until the
engine has cooled down. Observe the
safety instructions regarding the fuel!
Warning
The fule tank on the engine is not connec-
ted (only applies to AS 63 2T ES, AS 63 4T
B&S, AS 63 4T Honda).
Filled fuel can run out and ignite.
► Never fill fuel into the tank on the engine.
Filling up with fuel
1. For filling, use a canister with filler spout or
a funnel.
2. Open the canister carefully so that existing
excess pressure is slowly reduced.
3. Open the tank cap carefully so that existing
excess pressure is slowly reduced and no
fuel sprays out.
4. Fill the fuel tank.
5. Tightly close the tank cap again.
