Indexer System Guide
October 2004
© As-Built Solutions Ltd
Page
5
Briefly press the yellow button on the Indexer side panel and release. The top plate should rotate to the
first camera position and capture an image. It will then rotate to the second position and capture the
second image.
If a series of beeps two then three ##_###_##_### is heard at the first position then the Indexer is unable
to communicate with the camera. Any other warning sequences should be reported to technical support
for diagnostics to be carried out.
To delay capture to avoid being in the images press and hold the yellow button. A series of beeps will
heard. Each beep equates to a 5-second delay. The maximum delay is 20 seconds achieved when the
button is released after 4 four beeps.
If the button is held beyond the four beeps a series of very rapid beeps is heard this is a calibration mode
used by servicing engineers.
To stop t
h
e unit
at
any time simply press the yellow button briefly.
1.5.2
Using the remote control button
The unit is supplied with a remote control interface. This is particularly suited to operation of the unit
when it is positioned at a high level or careful control is needed over the exact moment an image is
captured.
The remote control is fitted in the interface on the panel with the yellow button. Take care to ensure it is
orientated correctly with the black release button at the top.
To start a panoramic sequence with user control over the instant at which image is captured capture press
the green button. The unit will drive to the first image position and the LED will flash. Pressing the green
button again will capture the image.
