8
ARZUM
9
ARZUM
• Discharge the water from the kettle, and wipe the outside of it thoroughly
with a dry or damp cloth.
•
NEVER
immerse the power base unit and the kettle into water, nor wash
them in a washing dish machine.
• Avoid using abrasive and chemical cleaning agents (liquid bleach,
hydrochloric acid, etc.) in cleaning any accessories of the appliance.
Cleaning the Water Filter
• Water filter is placed on the inner side of
the spout. It holds foreign matters, limes,
and scales, which may be contained in the
water.
• After each use, the water filter should be
held under running water, and cleaned with
a soft brush.
• If excessive amounts of lime and scale have accumulated on the filter.
- Place the water filter in a vessel filled with the vinegar (or citric acid).
- Let the vinegar remain inside the vessel for half an hour.
- Then, hold the water filter under current
of hot water until any remaining scale and
vinegar are removed.
• Cleaning frequency depends upon the
area (such as dusty) in which the kettle is
used.
• In cleaning the water filter
NEVER
use dishwashing detergents or special
descaling agents.
Descaling
• It is important the kettle is descaled
regularly as appropriate, for the hygiene
and energy saving purposes.
• Limes and scales contained in the used
water will form a brown layer on the heating
base, reducing the effectiveness of your
appliance.
• If you desire to stop the boiling function you
can turn the main switch (on/off switch) to the
position “0”.
• When filling the kettle with water,
ALWAYS
remove the appliance from its power base unit.
By doing so, you can prevent the water from
pouring on the table.
• Do not fill with less than 0.5 liter of water (less
than “MIN” indication) or more than 2,0 liter of
water (more than “MAX” indication).
If you attempt to boil a quantity of water below the minimum level or above
the maximum level, the appliance may switch off rather early or the boiling
water may eject from the spout, respectively.
• When not in use, provided that the main switch is turned off “O”, it would be
convenient to allow the appliance to stay continuously plugged in the kitchen.
SWITCHING ON AGAIN
• If you want to re-boil the water make sure that
your appliance has cooled down sufficiently.
Should the on/off switch turn to the position “0”
automatically, do not force it to the position “I”.
Otherwise, you may damage to your appliance.
CLEANING
• Before cleaning your appliance, first
ALWAYS
read the instructions in the
section “Important Safeguards”.
BEFORE CLEANING TURN OFF “0” THE MAIN SWITCH (ON/OFF SWITCH),
UNPLUG FROM OUTLET, AND ALLOW IT TO COOL DOWN.
EN
