UniFace Owner’s Manual V2k8.1 CE © 2008 ARX Systems®
UniFace Owner’s Manual V2k8.1 CE © 2008 ARX Systems®
2
7
Specifications
Complete online documentation is available on the ARX website:
www.arx.com.au/uniface.htm
Specific queries can be emailed to the factory at
ARX® is a Registered Trade Mark of ARX Systems Pty Ltd. Uni-
Face™ is a trade mark of ARX Systems Pty Ltd. Any other names
and trademarks are used for information purposes only, and no other
intent is either expressed or implied
This symbol indicates that a Slow Blow
fuse is used in this equipment. Replace
with same type and value only
This symbol is intended to alert you to
the presence of uninsulated dangerous
voltage within the product's enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock.
This symbol is intended to alert you to
the presence of important operating
instructions contained in this owner's
manual
WARNING SYMBOLS USED
ON THIS EQUIPMENT
IMPORTANT
- PLEASE READ THIS FIRST
THIS IS A DUAL VOLTAGE UNIT. IT IS ESSENTIAL THAT YOU CHECK THAT THE VOLTAGE ON
THE FUSEHOLDER COVER BELOW THE AC CONNECTOR ON THE REAR OF THE CHASSIS IS
SET CORRECTLY BEFORE CONNECTING IT TO AC POWER.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not insert power
cable into unit until voltage has been correctly set. Do not connect power cable to AC
power until voltage has been correctly set
THIS IS SET FOR 100 V
AC TO 120 V AC
OPERATION
THIS IS SET FOR 220 V
AC TO 240 V AC
OPERATION
Complies with 89/336/EEC EMC Di-
rective, amended by 92/31/EEC and
93/68/EEC; meets the following
standards:EN 55013 : 1990, Sections
3.2 and 3.5, EN 55020 : 1988, Sec-
tions 4.3, 5.4, 6.2, 7.0, 8.0., and EN
60950 : 1994 Low Voltage Directive
Complies with Australian Standard AS/
N25 1053
Our policy is one of continuous im-
provement, and therefore designs may
change without notice. However, un-
less otherwise stated, specifications
will always equal or exceed those pre-
viously given.
Input Impedance
44K Ohms balanced
Output Level
(Max) +21dB
AGC Threshold
–40 to 0 dB
AGC Output Gain
–20 to +20 dB
Output Signal/Noise
(@ unity gain)
-90dB A weighted, all inputs @ Unity, Master @ Unity
Dynamic Range
115dB
System Master Outputs
Electronically Balanced Male XLR
300 ohms: Pin 1 Ground, Pin 2 +, Pin 3 –
Recording Outputs
Transformer isolated Balanced Male XLR,
wired Pin 1 Not Connected, Pin 2 +, Pin 3 –
Frequency Response
20Hz-20 KHz ± 1dB
Distortion (@ unity gain
Below 0 .001%, 100 Hz to 10KHz
Input Connector Type
Female XLR