UniMIX Owner’s Manual V3.0 CE © 2010 ARX Systems®
UniMIX Owner’s Manual V3.0 CE © 2010 ARX Systems®
2
7
Specifications
Input Impedance
Mic 4K Ohms Balanced
Line 22K Ohms Unbalanced
Input Gain
Microphone Variable 10 dB to 50 dB with rear trim control
Mic / Line switch -20dB
Output Level
( Max) +21dB
AGC Threshold
–40 to 0 dB
AGC Output Gain
–20 to +20 dB
Phantom Power:
+48VDC switchable on all Microphone Inputs
Output Signal/Noise
-90dB A weighted, all inputs @ Unity, Master @ Unity
Dynamic Range
115dB
Master Output EQ
Low 100Hz 15dBCut/Boost
Mid 800HZ 15dB Cut/Boost Bell, Broad Q
High 10KHz 15dBCut/Boost
Master Outputs
Electronically Balanced XLR 300 ohms Line Level Balanced
Output Connectors Male XLR: Pin 1 Ground, Pin 2 +, Pin 3 –
Frequency Response
20Hz-20 KHz ± 1dB
Distortion (@ unity gain
Below 0 .01%, 100 Hz to 10KHz
Input Connector Type
Mic/Line - Amphenol Female XLR
Hi Z Input - Phono (RCA type)
Output Connector Type
Amphenol Male XLR
Recording Output Connector Type
Amphenol Male XLR
Complete online documentation is available on the ARX website:
www.arx.com.au/unimix.htm
Specific queries can be emailed to the factory at
ARX® is a Registered Trade Mark of ARX Systems Pty Ltd. MSX48™ is a
trade mark or ARX Systems Pty Ltd. Any other names and trademarks are
used for information purposes only, and no other intent is either expressed
or implied
This symbol indicates that a Slow Blow
fuse is used in this equipment. Replace
with same type and value only
This symbol is intended to alert you to
the presence of uninsulated dangerous
voltage within the product's enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock.
This symbol is intended to alert you to
the presence of important operating
instructions contained in this owner's
manual
WARNING SYMBOLS USED
ON THIS EQUIPMENT
IMPORTANT
- PLEASE READ THIS FIRST
THIS IS A DUAL VOLTAGE UNIT. IT IS ESSENTIAL THAT YOU CHECK THAT THE VOLTAGE ON
THE FUSEHOLDER COVER BELOW THE AC CONNECTOR ON THE REAR OF THE CHASSIS IS
SET CORRECTLY BEFORE CONNECTING IT TO AC POWER.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not insert power
cable into unit until voltage has been correctly set. Do not connect power cable to AC
power until voltage has been correctly set
THIS IS SET FOR 100 V
AC TO 120 V AC
OPERATION
THIS IS SET FOR 220 V
AC TO 240 V AC
OPERATION
Complies with 89/336/EEC EMC Di-
rective, amended by 92/31/EEC and
93/68/EEC; meets the following
standards:EN 55013 : 1990, Sections
3.2 and 3.5, EN 55020 : 1988, Sec-
tions 4.3, 5.4, 6.2, 7.0, 8.0., and EN
60950 : 1994 Low Voltage Directive
Complies with Australian Standard AS/
N25 1053
Our policy is one of continuous im-
provement, and therefore designs may
change without notice. However, un-
less otherwise stated, specifications
will always equal or exceed those pre-
viously given.
