DI-6
SM
Owner's Manual v 1.1 CE ©2006 ARX®
DI-6
SM
Owner's Manual v 1.1 CE ©2006 ARX®
2
7
DI-6s Specifications
Channels 1 - 6
Input Impedance
2 MegOhm
Input Headroom
+21 dB
Output Signal/Noise
-98 dB Unweighted
-104 dB A weighted
@ unity gain
Output Level (Max)
+26 dB
Dynamic Range
124 dB
Frequency Response
20 Hz to 20 KHz -0.5dB
Distortion (@ unity gain) 100 Hz .004%
1 KHz .003%
10 KHz .005%
Input/OutputConnector Type
Jack
Balanced Output Type
XLR
Master Section
Output Signal/Noise
All Inputs at unity, Master at unity
-90 dB unweighted
-96 dB A weighted
Output Level (Max)
+26 dB
Output Impedance
600 ohms
Distortion
.006% @ 1 KHz, unity gain
Output Connector Type Jack and XLR
Splitter Input
Maximum Level
+20 dB
Input Impedance
20 Kohms Balanced
Input Connector Type
XLR
Power Requirements
100/110 or 220/240V AC 50/60 Hz
8 Watts (8 VA)
Weight
5 lb/2.2 Kg
Dimensions
19"W x 1¾"H x 6"D
482 x 44 x 155 mm
This symbol indicates that a Slow Blow fuse is used in this equip-
ment. Replace with same type and value only
This symbol is intended to alert you to the presence of uninsulated
dangerous voltage within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock.
This symbol is intended to alert you to the presence of important
operating instructions contained in this owner's manual
WARNING SYMBOLS USED ON THIS EQUIPMENT
IMPORTANT
- PLEASE READ THIS FIRST
This is a dual voltage unit. It is essential that you check that the voltage
on the fuseholder cover below the AC connector on the rear of the chassis
is set correctly before connecting it to AC power.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not
insert power cable into unit until voltage has been correctly set. Do not plug
power cable into AC power until voltage has been correctly set
THIS IS SET FOR
100 V AC TO 120 V
AC OPERATION
THIS IS SET FOR
220 V AC TO 240 V
AC OPERATION
Complies with 89/336/EEC EMC Directive,
amended by 92/31/EEC and 93/68/EEC and
meets the following standards:EN 55013 : 1990,
Sections 3.2 and 3.5 EN 55020 : 1988, Sec-
tions 4.3, 5.4, 6.2, 7.0, 8.0.
Complies with Australian Standard AS/N25
1053
