AmbiDrive/MicroDrive Owner's Manual v3.1 ©2000 ARX®
AmbiDrive/MicroDrive Owner's Manual v3.1 ©2000 ARX®
2
7
Specifications
Input Impedance
40 Kohms electronically balanced
CMRR
>70 dB, @ 1 KHz
Cnannel Separation
-88 dB, unweighted
Distortion (THD)
.04% @ +4 dB, 1 KHz
Crossover Frequency100Hz (to SUB channel)
HighPass Filters
35 Hz SUB output
45 Hz A/B outputs
Input Connectors
XLR and Jack
Output Connectors
Neutrik Speakon
Power Requirements
100, 120, 220, 240V AC, 50-60 Hz,
supplied Zone Specific
Output Power - AmbiDrive
Channels A and B
140Watts/8 ohms, 180Watts/4 ohms
Sub Channel
160Watts/8 ohms,210Watts/4 ohms
Output Power - MicroDrive
Channels A and B
180Watts/8 ohms, 250Watts/4 ohms
Sub Channel
230Watts/8 ohms,320Watts/4 ohms
Maximum Units Driven
AmbiDrive:
2 x Ambience 1 or 5 per side
from Channels A and B;
1 x Ambi SUB from Sub Channel
MicroDrive:
2 x MicroMedia per side
from Channels A and B;
1 x M-SUB from Sub Channel
Weight
AmbiDrive: 12 Kg (26 lbs)
MicroDrive: 13 Kg (28 lbs)
Front Panel Controls
Power switch, Level controls for Channels A,
B and Sub.
Construction
All steel monococque construction
This symbol indicates that a Slow Blow fuse is used in this equipment.
Replace with same type and value only
This symbol is intended to alert you to the presence of uninsulated danger-
ous voltage within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock.
This symbol is intended to alert you to the presence of important operating
instructions contained in this owner's manual
WARNING SYMBOLS USED ON THIS EQUIPMENT
IMPORTANT - This amplifier is designed to be
connected ONLY to the AC voltage ticked below
100 V AC, 50 - 60 Hz
120 V AC, 50 - 60 Hz
220-240 V AC, 50 - 60 Hz
240 V AC, 50 - 60 Hz
!
It is essential that you check that
this voltage is correct for your
area before connecting it to AC
power. Do not plug power cable
into AC power until voltage has
been checked. If incorrect, contact
your ARX distributor.
Your warranty does not cover
connecting the amplifier to the
wrong voltage AC power!
FUSE
These amplifiers have a removable AC power lead
that connects to an IEC connector (See Picture at
Right) with built in fuse. Replace fuse with correct
value as marked on the rear of the amplifier
Complies with 89/336/EEC EMC Directive,
amended by 92/31/EEC and 93/68/EEC and
meets the following standards:EN 55013 : 1990,
Sections 3.2 and 3.5 EN 55020 : 1988, Sections
4.3, 5.4, 6.2, 7.0, 8.0.
Complies with Australian Standard AS/N25
1053