ArWest 01-00011-110, Руководство пользователя, Страница: 25 / 48

Command Line Interface
Networking Commands
CONNECT
25 www.arwestcom.com
3.2. Networking Commands
3.2.1. CONNECT
To connect the radio unit through the local maintenance serial port or to establish the link with the
remote unit in the Point-to-Multipoint network, the CONNECT command must be used.
CONNECT [Unit_Numb] [/?]
Where the Unit_Numb is an assigned decimal number for the unit to be connected. To get the
complete unit list, the CONNECT command must be used with no parameter. The list of units in
the Point-to-Point link with the connection established with remote unit is shown in Figure 3-1:
Figure 3-1. Connection List
To disconnect from the remote unit and connect to the local unit, the parameter (Unit_Numb)
must be equal to 0x00.
3.2.2. LINK
The LINK command is responsible for configuring radio’s operation mode. It has six parameters
listed below.
LINK [Parameter Name] [Parameters List] [/?]
Unit Serial Number Connect
BS 003578659922
1 003574459923 C
Parameter Name Parameter List
CHAN Selects the Channel Number: CN = 1 to 32.
Each Channel is defined by three parameters: Carrier Frequency, Channel
Spacing and Allowed Output Power level.
CN = 0 is reserved to set up the Frequency Automatic scanning mode.
The LINK CHAN 0 command also forces the radio modem to continue scanning
starting from the channel currently selected by automatic scanning algorithm.
In Automatic scanning mode, to check the channel currently used or scanned,
the STATE command must be used
FEC 0 – Disable Forward Error Correction, a default setting (see note below)
1 – Enable Forward Error Correction (see note below)
FHOP (1 – 32) – Frequency Hoping Pattern number LINK FHOP command can be processed
only if the Channel Map (up to 32 channels) is defined by AWLaunch or by MAP
command.