User Manual
[1.0]
Page 6
Connecting guidelines
CONNECTING THE CONTROL MODULE
The control module is installed on the board of navigation tracker Arnavi Integral 3 by point
soldering to the main connector of the tracker as shown in picture 3.
Picture 3. Navigation tracker Arnavi Integral 3 with the installed control module
Connection of the control module to other trackers is carried out as follows:
VCC point:
+12V DC with battery. Connect to the power line of the tracker, which is constantly present
v12V.
At this point, the control module transmits signals to the blocking relay. To ensure reliable control, the
relay and control module must be electrically connected via this wire.
GND point:
"MASS". Connect to the "GND" (minus) line of the tracker, which is connected to the
negative terminal of the battery.
Exit point:
Connect to the tracker's "out" pin.
CONNECTING THE BLOCKING RELAY
Red wire:
+ 12V DC with battery. Connect to the battery or
to the wire of the car, which is constantly present v12V.
On this wire, the control module transmits signals to the blocking relay. To ensure reliable control, the
relay and control module must be electrically connected via this wire
Black wire:
MASS. Connect to the negative terminal of the battery.
