Aruba
6280 America Center Drive
San Jose, CA 95002
1.877.210.7325 (toll-free in USA)
+1.408.935.1850
www.silver-peak.com/support
EdgeConnect
Quick Start Guide
EC-US
© 2021 Aruba, a Hewlett Packard Enterprise company All rights reserved.
PN 201784 Rev A
1
Approve the Discovered Appliance
After you power on the EdgeConnect appliance, it automatically registers its serial number with
the Silver Peak Cloud Portal. The portal knows how to associate a serial number with a particular
account.
a. Go to the Orchestrator.
b. In the header, click the blinking box named
Appliances Discovered
.
The
Discovered Appliances
page opens, listing the most recently discovered appliances first.
c. After verifying that the appliance is yours, click
Approve
.
d. Select the group and click
Apply
.
The Appliance Manager Configuration Wizard opens.
2
Complete the Appliance Manager Configuration Wizard
a. If you’ve also purchased
EdgeConnect Boost
or
EdgeConnect Plus
, and you want to apply it to this
appliance, select the relevant check box(es) on the
Deployment Profile
page.
b. At the end, click
Apply
. It may take up to two minutes to register the appliance.
c. Complete the remaining wizard screens.
• On the
Deployment
page’s default configuration, the WAN–side interfaces use DHCP IP ad
-
dresses, unless you manually enter static IP addresses.
Before You Begin
Make sure that Orchestrator is
installed and registered.
Verify that you’ve received the
email containing your Account
Name and Account Key.
Part 2 - Registration
IMPORTANT - READ THIS FIRST:
You must install and register your Orchestrator
with the Silver Peak Cloud Portal
BEFORE
setting up an EdgeConnect appliance. After
Orchestrator is registered with your account name and key, you can proceed with
EdgeConnect installation.
If you don’t know or are unsure what role the Orchestrator plays, please contact your
network architect or deployment lead.
