Aruba AP-85, Руководство по установке

Страница: 22 / 50

22 | AP-85 Series Installation Aruba AP-85 Outdoor Access Point Series | Installation Guide
Verifying Pre-Installation Connectivity
Before you install APs in a network environment, make sure that the APs will be able to locate and connect to the Mobility
Controller when they are powered on.
Specifically, you must verify the following conditions:
z
When connected to the network, each AP is assigned a valid IP address.
z
APs can locate the Mobility Controller (Mobility ControllerDiscovery).
Refer to the ArubaOS Quick Start Guide for instructions on locating and connecting to the Mobility Controller.
Provisioning the AP
Each AP has unique provisioning parameters. These local AP parameters are initially configured on the Mobility Controller.
The Mobility Controller pushes the parameters out to the specific AP, where they are stored. Aruba recommends that you
configure the provisioning settings using the ArubaOS Web UI only. Refer to the
ArubaOS User Guide for complete details.
Installing the AP-85
N O T E
Aruba Networks, in compliance with governmental requirements, has designed the AP-85 such that
only authorized network administrators can change configuration settings. For more information
about AP configuration, refer to the ArubaOS Quick Start Guide and ArubaOS User Guide .
!
CAUTION
Access points are radio transmission devices and as such are subject to governmental regulation.
Network administrators responsible for the configuration and operation of access points must
comply with local broadcast regulations. Specifically, access points must use channel assignments
appropriate to the location in which the access point will be used.
N O T E
If the AP-85 is to be deployed in a mesh networking environment, the AP-85 must be provisioned as
a mesh portal or a mesh point before deployment.
!
CAUTION
RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits.
This equipment should be installed and operated with a minimum distance of 13.8 inches (35 cm)
between the radiator and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
!
CAUTION
Aruba Access Points, AP-LAR-1 lightning arresters, and cable termination kits must be installed by
trained service personnel. These installers are responsible for ensuring that grounding is available
and that grounding meets applicable local and national electrical codes.