Aruba Networks S2500 Series, Руководство по установке

Страница: 27 / 40

Aruba S2500 Series Mobility Access Switch | Installation Guide Installation | 27
Mid-Mount Rack Mounting
The included mid-mount rack mounting kit provides the necessary hardware to securely mount an S2500 in
standard 19” Telco rack.
Required Tools and Equipment
The following tools and equipment are required for installation of an Aruba S2500 mobility access switch:

Mid-Mount Bracket (x2, not used for tabletop installation)

M4 x 8mm Phillips Flat Head Screws (8x, included with rack mount brackets)

M6 x 15mm Phillips Flat Head Screws (4x, 19-inch (48.26 cm) rack system mount screws).

Suitable Screwdrivers for both screw types.
Installation Steps
To install an Aruba S2500 mobility access switch into a two-point 19-inch (48.26 cm) rack system:
1. Place a rack mount bracket over the mounting holes on one side of the mobility access switch (see
Figure 12 ).
2. Secure the bracket to the mobility access switch using four M4 x 6mm phillips flat head screws and a
suitable screwdriver.
3. Repeat these steps on the opposite side of the mobility access switch.
Figure 12 Mid-Mount Brackets
4. Mount the mobility access switch within your organization’s rack system using four (two per bracket)
M6 x 15mm phillips flat head screws and suitable screwdriver (see Figure 13 ).
Each S2500 should have its own mounting equipment. Do not place other networking equipment directly on top a
mounted S2500. Failure to do so can result in damage to the device.
Some racks require screws that differ from those included with the S2500. Confirm that you have the correct
screws before installing your S2500.
Amarone_06