Arturia JUP-8V, Руководство пользователя

Страница: 55 / 69

ARTURIA – Jup-8 V – USER MANUAL 55
4.2.3 The edit section of the sequencerOutputs
The modulation destination (“OUTPUT”) is located to right of the interface of
the sequencer, where the synthesis parameters that will be affected by the
sequencer are selected.
It is also possible to connect the parameters of the voice effects to the
sequencer. To do that, go to the “Effects” / “Voice Effects” page. Then choose
the source “Sequencer” among the choices of sources of proposed
modulations for the parameters of these effects. (see paragraph “Voice
Effects” for more details)
Three connection locations are available for the sequencer.
For each of them the following destinations are available:
 DESTINATION: Choice of available modulation destinations
o
None: Nothing is connected
o
VCO1 Pitch: VCO1 FREQUENCY
o
VCO2 Pitch: VCO2 FREQUENCY
o
VCO1 PW: Pulse width of the square wave form of VCO1
o
VCO2 PW: Pulse width of the square wave form of VCO2
o
HPF Cutoff: Frequency of the high pass filter
o
VCF Cutoff: Frequency of the low pass filter
o
VCF Res: Resonance of the low pass filter
o
VCA: Volume of the VCA
 AMOUNT: Sets the level of modulation
 Q: Quantification of the modulation settings by semitones. This
parameter is essential to regulate the levels of each step for the creation
of a melodic sequence
 RETRIG: Automatically place a «trig» envelope on all the steps.
The connection section