
58
INTRODUCTION
INTRODUCTION
Figure 109 - CattleMaxx With Auger Feeder (A
– PTO Driveline; B – Rollermill; C – Mixing Tank; D – Dust
Collector; E
– Supplement Hopper; F – Unloading Auger; G – Viewing Windows; H – Auger Feeder).
This manual has been prepared to make you
familiar with the proper operation, adjustment,
lubrication and service of your CattleMaxx. Take
time to be careful and better understand the
efficient operation and care of your machine.
Whenever the terms “
Left
” and “
Right
” are used, it
should be understood to mean standing behind the
machine and facing the direction of forward travel.
Some pictorials are used to show guards, doors
and shields removed for easy identification.
Make sure that all guards, doors and shields are
in place before operating the machine. They are
for your protection.
The Art’s-Way CattleMaxx is driven by a PTO
driveline of 40 hp to 130 hp tractors and is factory
available with a 540 RPM drive.
Always operate at full speed while rolling grain.
CAUTION: NEVER OPERATE A 540
RPM PROCESSOR WITH A 1000 RPM
TRACTOR.
The rollermill (Figure 109, Detail B) is precision built
of tough, cast iron construction, designed to give a
high degree of control over the quality of feed
produced.
It is important that you become acquainted with
your rollmill before operating at full capacity. The
rollermill will not start with grain between the rolls.
If supplement is to be added to the ration, a hopper
(Figure 109, Detail E) with a sack cutter is located
at the right rear of the mixing tank. The best mixing
will result if the supplement is added before
grinding.
The rolled feed is mixed continuously until the
tractor PTO is disengaged.
The unloading auger (Figure 109, Detail F) pivots at
the rear center of the mixing tank and can swing
324 degrees on the 6105 CattleMaxx or in a
horizontal arc and in a vertical arc to the limit of the
lift assist spring. The unloading auger tube can be
positioned either to the right or to the left side of the
tank for transport. Unloading rates up to 30 bushels
per minute can be obtained depending upon
B
C
H
G
F
A
D
E
Содержание CATTLEMAXX 6105
