Art's-Way Manufacturing 6812A, Руководство оператора

Страница: 51 / 64

TRANSPORTING THE HARVESTER 49
DEALER ASSEMBLY INSTRUCTIONS
P
RE
-D
ELIVERY
CAUTION: THE HARVESTER HAS A TOTAL
WEIGHT RANGING FROM 29,000 LBS
[13,145 KG] FOR THE 6 ROW 28/30 TO
35,400 LBS [16,057 KG] FOR THE 12 ROW
22. WHILE WORKING ON THE MACHINE BE
SURE TO WORK SAFELY. BE SURE TO
USE ADEQUATE BLOCKING. USE
ADEQUATELY RATED LIFTING DEVICES.
MAKE SURE PARTS ARE SECURED
BEFORE WORKING UNDER OR NEAR
THEM.
Check harvester and head for various components:
Main Frame Unit, Head, Short Conveyor, Stripper,
Grates for Truck Conveyor. If 12 row 22 or 8 row 30
machine also find Gage Wheels and Truck Conveyor
Extension.
NOTE: A hoist or lift truck is necessary to assembly the
harvester this must be capable of reaching
across the head and picking up and moving the
tongue of the machine which weighs
approximately 1000 pounds.
It also must be capable of lifting the heads,
which are approximately 8,000 & 10,000 pounds
for the 6 row 28/30 & 8 row 22. The 12 row 22
weighs approximately 14,000 pounds (8 row 30,
11,000 pounds). The Main Frame Unit weighs
approximately 22,000 pounds.
NOTE: Parts required for assembly are stored in the
side shields of the head and the rear shield of
the harvester, remove for assembly.
NOTE: Set the frame on a level area to assemble. Set
the header lifter wheels on a board so they do
not penetrate into soft ground.
A
SSEMBLY
I
NSTRUCTIONS
Figure 84 - Wheel & Tire Installation
1. Installation of wheel and tire assemblies.
2. Adjust the axle to the outer most position.
a. Install the left- and right-hand wheel and tire
assemblies on the hub and spindle assembly.
Larger distance of the dish in on the 8 row 22/
6 row 30; dish out on the 8 row 30 & 12 row 22.
Tires in the ground drive direction (Lugs point
rearward on the top of the tire).
b. Secure each wheel and tire assembly to the
hub and spindle assembly using ten nuts
provided.
c. Install the rubber flap to the inside of the axle to
close up where the axle had extended over the
grabrolls.
Figure 85 – Axle Grate Installation
3. Install tongue to cross hitch (see Figure 86). Parts
loosely attached. If needed, install the front hitch
swivel to the tongue with the six (6) 1 inch (2.54
cm) x 3.0 inch (7.62 cm) bolts provided.
Figure 86 – Harvester Hitch Area