Arts Energy Smart Module, Руководство пользователя

Страница: 5 / 17

5
Using the battery:
Connect the battery discharge cables to the main discharge
poles (1 & 6 as indicated on the front cover photograph of this
manual). Switch on the appliance and use until the battery is
fully discharged. Depending on the current drained in the
battery, the status LED indicates the following:
Green Discharge

If the discharge current is higher than 100 mA,
the gas gauge LEDs light up

When the signal on Specific PreAlarm
connector is ON, the battery is close to the end of
discharge
Orange Regenerative charge

Battery receives a charge current higher than
100 mA

When the signal on Specific PreAlarm
connector is ON, the battery is close to
regenerative charge limit (*)

When the regenerative charge is not allowed,
the battery switches to Charge mode and may
pulse the incoming current
OFF Standby , battery disconnected

No voltage on main discharge poles
(*): only when the regenerative alarm option is selected For
some configurations, the battery can accept a regenerative
charge. This function allows recovering energy from a motor or
a reversible device powered by the Smart Module.
It is recommended to start to use the battery when the battery
temperature is in the -10°C to +40°C range.
It is possible to start the discharge from -20°C to +60°C
occasionally. However the service life will be reduced by using
the battery at high temperatures.