Studio Soundbar TV Mount Installation Guide | 009-2001-00
45 Perseverance Way, Hyannis, MA 02601
Copyright 2020 Savant Systems, Inc | 201216
2 of 2
www.savant.com/artisonspeakers
Attach Soundbar Brackets to TV
The steps below detail the process for attaching the bracket to the
back of the TV.
1. Choose the desired mounting bracket. Use the Bracket Selection
table on the previous page.
2. If necessary follow the instruction in the Change Bracket Type
section on the previous page.
3. Remove the TV from the Mount/Stand.
4. Place the TV display side down on a soft non-abrasive surface
5. Remove any existing mounting bracket and screws from the VESA
mounting points.
VESA
mounting points
6. Gently place the Soundbar face down on the same surface as the
TV, as to not damage the front tweeters.
7. Align the Soundbar to the desired location above or below the TV.
8. Adjust the length of the mounting brackets and align the mounting
brackets to the TV’s VESA points.
9. Insert undermount spacer.
Brackets
Aligned with the VESA mounting points
Undermount
Spacer
10. Attach the mounting bracket to the TV. The soundbar brackets
should be between the TV and the TV mount. Hand tighten the
VESA bolts only at this time.
Bracket Installation
Attach Soundbar to Brackets
The steps below detail the process for attaching the Soundbar to the
mounting brackets after the TV is installed onto the original mount/
stand.
1. Reattach the TV onto the mount/stand.
2. Adjust the height of the Soundbar bracket.
NOTE:
If the L/C-Shaped bracket does not slide easily loosen the
VESA bolts 1/2 turn.
3. Attach the optional extension brackets if needed.
4. Align the mounting slides in the Soundbar.
5. Attach the Soundbar to the mounting bracket.
Optional Extension Bracket
L-Shape Bracket shown here
6. Tighten all mounting bolts and screws.
UMB Stabilizers
It is recommended to use the UMB stabilizers for added stability,
however for smaller TVs it may not be necessary. Refer to the UMB
Stabilizers steps below before proceeding to the Attach Soundbar to
Brackets section.
1. Locate a section of the TV’s chassis as close to the end of the
Slider Arm that is flat enough to mount the stabilizer foot
preferably close to the edge of the TV.
2. Clean the intended attachment area on the TV chassis with an
alcohol wipe to remove any latent grease.
3. To install the Slider Arm, first screw one of the Stabilizer Nuts onto
the thread, close to the swivel base. Place the assembly underneath
the Slider Arm and insert the threads through the Arm slot.
4. Once in place, peel the red backing film off of the base and stick
firmly to the TV chassis.
5. Install the second nut onto the threads and tighten both in place to
hold the speaker brackets in the correct placement.
Back of the TV
Mounting Bracket
UMB Stabilizer
6. Break off the any additional thread of the stabilizer with a pair of
pliers.
