4 of 6
Fig. 7 (attaching a fuel can holder)
ATTACHING AND OPERATION
Fig. 8 (cam lever in the open position)
Fig. 9 (cam lever in the closed position)
rotate both cam levers up
to install the fuel can holder
padlock holes
rotate both cam levers down
to secure the fuel can holder
ATTACH TO MOUNTING BAR:
Note: The Artillian ROPS Mounted Toolbar is designed to
hold multiple accessories at one time. If placed appropriately,
up to 3 separate accessories may be possible. For example,
the Chainsaw Mount, Fuel Can Holder, and Beverage Cooler
Holder were designed to fit on the toolbar simultaneously.
7. Fig. 7 shows a fuel can holder installed onto an
Artillian ROPS Mounted Tool Bar.
8. To install the fuel can holder, rotate both cam levers
UP, then place onto the Tool Bar. See fig. 8.
Note: if the Cam Lever Latches do not sit flush on the Tool Bar, one
of the clamp plates may not have been fully open. Simply remove the
fuel can holder, rotate the cam levers up and tilt the fuel can holder
away from you to ensure the clamp plates are fully open, then
reinstall on the Tool Bar.
9. To secure the fuel can holder to the Tool Bar, rotate
both cam levers DOWN until they cam over. See
fig. 9.
NOTE: For additional security, the fuel can holder can be locked to
the Tool Bar by inserting a padlock through the holes in the mounting
bracket where shown in fig. 9.
10. To remove the fuel can holder from the Tool Bar,
rotate both cam levers UP, then lift the fuel can
holder.
OPERATION
11. For optimal functionality, the cam lever latches are
factory assembled with some friction between the
cam lever and the housing. This ensures the cam
lever doesn’t accidentally flip closed while the user
attempts to install it on the bar. If the cam levers
loosen up over time, simply tighten the nut and bolt
that secure the lever to the housing until the
desired resistance on the cam lever has been
achieved.
