4 of 6
Fig. 7 (attaching a beverage cooler holder)
ATTACHING AND OPERATION
Fig. 8 (cam lever in the open position)
Fig. 9 (cam lever in the closed position)
rotate both cam levers up to
install the beverage cooler holder
padlock holes
rotate both cam levers down
to secure the beverage
cooler holder
ATTACH TO MOUNTING BAR:
Note: The Artillian ROPS Mounted Toolbar is designed to
hold multiple accessories at one time. If placed appropriately,
up to 3 separate accessories may be possible. For example,
the Chainsaw Mount, Fuel Can Holder, and Beverage Cooler
Holder were designed to fit on the toolbar simultaneously.
7. Figure 7 shows a beverage cooler holder installed
onto an Artillian ROPS Mounted Tool Bar.
8. To install the beverage cooler holder, rotate both
cam levers UP, then place onto the Tool Bar. See
fig. 8.
Note: if the Cam Lever Latches do not sit flush on the Tool Bar, one
of the clamp plates may not have been fully open. Simply remove the
beverage cooler holder, rotate the cam levers up and tilt the
beverage cooler holder away from you to ensure the clamp plates are
fully open, then reinstall on the Tool Bar.
9. To secure the beverage cooler holder to the Tool
Bar, rotate both cam levers DOWN until they cam
over. See fig. 9.
NOTE: For additional security, the beverage cooler holder can be
locked to the Tool Bar by inserting a padlock through the holes in the
mounting bracket where shown in fig. 9.
10. To remove the beverage cooler holder from the
Tool Bar, rotate both cam levers UP, then lift the
beverage cooler holder.
OPERATION
11. For optimal functionality, the cam lever latches are
factory assembled with some friction between the
cam lever and the housing. This ensures the cam
lever doesn’t accidentally flip closed while the user
attempts to install it on the bar. If the cam levers
loosen up over time, simply tighten the nut and bolt
that secure the lever to the housing until the
desired resistance on the cam lever has been
achieved.
