User Manual explosion-safe AR-030 door magnet
4 / 6
Issue April 2020
Mounting:
Ø 4.5 mm mounting holes (4x), mutual distance 55 x 55 mm
Holding force:
490 N
Supply voltage:
24 V AC/DC ± 10%
Power:
100 mA AC / 63 mA DC
Sealed against moisture and dust:
IP65 according to EN 60529
Position:
Adjustable (360º)
Activation time:
100%
Electrical connections:
Cable, color coded, 3 x 1 mm², length 5 meters
Weight:
770 grams
7.
Marking and warning on the equipment
The marking label as shown below will be attached to the AR-030 Door Magnet.
8.
Installation instructions
Installation of explosion-safe equipment such as this product must be carried out by personnel specially trained
and qualified to do this, following the relevant requirements of the installation standard EN 60079-14.
For the installation and use of this product the relevant safety regulations and also the generally recognized latest
state of the technology apply.
During assembly, care must be taken that the framework, screws and surface are strong enough to take the
weight and the holding force of the door magnet.
Isolate power from the electrical supply cable prior to installation.
The door magnet is double isolated and therefore an earth connection is not necessary.
Install the connection cable and make sure that it is protected from mechanical and chemical influences.
Connect the end of the cable in a proper way to an external connection box and ensure this is done
professionally. The connection box is not supplied. Use a connection box that it is suitably protected for the
(explosion hazard) classification of the surroundings in which it will be used.
The connection cable has two wires. Both of them can be connected to the positive (+) or neutral (-) connection.
The door magnet is secured against voltage reversal and can be used with direct and alternating current.
AR-030 DOOR MAGNET
II 3 G Ex ec IIC T6 Gc, II 3 D Ex tc IIIC T80°C Dc
Year: 2020
Cert. ARTIDOR 20ATEX9999
24 VAC/DC, 1.5 W, IP65
TF & Serial No.: AS123456 F = 490 N
-25 °C < Ta < +50 °C
WARNING
ARTIDOR Explosion Safety B.V.
Emopad 38, 5663 PB Geldrop, The Netherlands, www.artidor.com
To avoid electrostatic charge clean only
with a damp cloth. Do not use solvents.
