ArTi WH FLAT 50-100L, Инструкция по эксплуатации, Страница: 3 / 34

arti.ua 3
EN
PRIOR TO INSTALLATION AND FIRST USE OF THE ELECTRIC WATER HEATER, PLEASE
CAREFULLY READ THESE INSTRUCTIONS
INSTRUCTIONS FOR INSTALLATION AND USAGE
Dear buyer, thank you for the trust you have shown by purchasing our product from the series
FLAT.
Advantage in the choice of model of electric water heater model FLAT.
The design of the water heater is extraordinary and has a purpose to make the room, where it
will be installed, more beautiful.
The quality of the elements which are built in is a guarantee for a long term usage of the water
heater.
The twenty-year experience in production of water heaters is a one more reason to believe in
the quality of our product that we offer, and we will prove this by its impeccable exploitation.
The water heater is produced by most modern machines and according to the most advanced
methods, and this guarantees lower spending of energy in a period of 24 hours. This is achieved
by use of isolation with PUR foam which is homogenous and very thick. The thickness of the
isolation guarantees minimal loss of warmth, after the water is being heated in the boiler.
There is a built- in digital display on which you can put the desired mode for heating, which
also guarantees minimal spending of energy. It is regulated in minimal spans of five degrees.
The memory of the set cycle of heating is optimized by this cycle of use.
The strength of the electric heater, also guarantees a small loss of electric energy in the pro-
cess of heating the water, and by this, a minimal appearance of limestone. At the same time, the
heating resistance of the electric heater is minimal.
The durability of the boiler is increased, it is made of material which is very thick and it is
protected by enamel which guarantees long durability if the exploitation is moderate.
MG anode is built- in which guarantees the protection of the enamel, and by this the durability
of the whole product is increased.
This water heater has been manufactured in compliance with the relevant standarts and tested
by the relevant authorities as indicated by the Safety Certificate and the Electromagnetic Com-
patibility Certificate.The technical characteristics of the product are listed on the label affixed be-
tween the inlet and outlet pipes. The installation must be carried out by qualified staff.
All repairs and maintenance work within the water heater, e.g lime removal or inspection/re-
placement of the protective anticorrosion anode, must be carried out by the authorised mainte-
nance service provider.
The water heater shall be built-in as close as possible to the outlets.When installing the
water heater in a room with bathtub or shower, take into account requirements defined in
IEC Standart 60364-7-701 (VDE 0100, Part 701).It has to be fitted to the wall using
appropriate rag bolts with minimum diameter of 10 mm. The wall with feeble charging ability
must be on the spot where the water heater shall be hanged suitably reinforced.