15
MOUNTING INSTRUCTIONS
Preparing the DynamicCableRetract
1- Place the DynamicCableRetract housing
with the brackets into the installed table
brackets as shown on the drawing below.
Insert the two M6 nuts.
2- Tighten each nut gradually until the
DynamicCableRetract top plate surface is flush
with of the table surface or cover plate:
- For the standard installation, flush the top
plate surface with the top surface of the
table.
- For the installation with cover plate, place
the cover plate over the table surface and
flush the top plate with the top Surface of the
cover plate. Do not stick the cover plate at
this moment.
