10
INSTALLATION INSTRUCTIONS
AH2 monitors are prepared to be assembled in the table by drilling four
holes (three for fixing nuts and one for cables). This version is supplied with
all the accessories to be assembled.
It is important to decide the correct position before making holes and to
bear in mind the dimensions of the monitor when it’s closed and open in
the working angle position.
Pattern Hole
Pattern hole dimensions for milling are specified in the general dimensions
for each model.
Attention
No stress should be applied to the product except from the instructions
given in this document. Cutting, drilling, soldering and adding electrical
and mechanical components can cause danger and should be
avoided by all means. Not complying with these directions will result in
a lost of the Arthur Holm warranty.
Albiral Display Solution S.L. shall not be hold liable for any loss or injury
incurred as a result of modifications made to the products by anyone
other than the supplier or the supplier's authorised representative
and with the supplier's written permission. Such modifications shall be
deemed to terminate any further guarantee obligations.
