24
INSTALLATION INSTRUCTIONS
Option V3:
- Veneer material can’t be conductor.
1. Check if the Veneer fits perfectly with the monitor. To join both parts
correctly it is important that the two surfaces are touching each other in the
whole length. If there is a gap between the Veneer and the monitor, check
if the hole depth in the Veneer is correct. (To make easier the adjustment
the height of the copper cylinder can be barely adjusted.)
2. Clean the top surface of the metal monitor housing and the bottom
surface of the Veneer.
3. Glue the Veneer. Double side tape or glue can be used (depending
on the kind of materials are going to be jointed). Double side tape or glue
used can’t be thicker than 0,2 - 0,25mm [0.008 0.01]
Veener Option 3 Cut-Out:
The pressure applied
must not exceed 1 Kg
evenly distributed on
monitor surface.
