DFU-0320-3 Rev. 0
9 of 20
Transmitter/Receiver Pairing:
For quick reference and set up, you may refer to the Synergy
Resection™
Wireless
Footswitch Quick Start Guide (DFU-0325-SUB-XX).
The following procedure needs to be followed if a transmitter or receiver need to be
replaced
1.
Make sure the footswitch has two (2) new AA alkaline batteries installed.
Batteries should be inserted with the + side first and the – side toward the battery
compartment cover cap (Figure 1).
2.
Make sure the receiver is connected to the shaver console that is powered on, via
a footswitch port. Consult the User Guide for the shaver console AR-8305 (DFU-
0213-XX) for more information if needed.
A.
The GREEN Power LED
should be on, indicating
connection to the console,
B.
All WHITE Directional
LED’s should be off, and
C.
The RED Battery LED
may be on (refer to step
9), off or flashing at this
point.
D.
Pairing Button
3.
To begin the footswitch and receiver pairing process, position the footswitch
vertically and within six (6) feet (1.8288 meters) of the receiver during the entire
pairing process.
NOTE:
Consistent completion of the
pairing operation between footswitch
and receiver may not occur if
batteries with insufficient power
(Total Battery Voltage is <=2.0V)
are installed.
Battery Compartment
Figure 1
C
A
B
D
Figure 2
Содержание Synergy Resection AR-8315W
Страница 1: ...Operator s Manual SynergyResection Wireless Footswitch AR 8315W DFU 0320 3 Rev 0 09 2019 ...
Страница 2: ...DFU 0320 3 Rev 0 2 of 20 This page intentionally left blank ...
Страница 14: ...DFU 0320 3 Rev 0 14 of 20 Transmitter Footswitch 1 2 3 4 5 8 6 7 ...
Страница 19: ...DFU 0320 3 Rev 0 19 of 20 This page intentionally left blank ...
