ARTEX/ACR Electronics, Inc.
A3-06-2824 Handheld Programmer Operations Manual
Y1-03-0272 Rev. F
Company Confidential
Page 32
4.7.12
National Location / ELT Serial (Long)
1.
Select ELT Baud rate.
2.
For the ELT 345 and ELT 1000, refer to Note 1 on page 23 before continuing.
3.
For the ELT 3000 and ELT 4000, refer to Note 2 on page 23 before continuing.
4.
Select Protocol.
5.
Select Country Code.
6.
Go to Graffiti screen and tap on letter/numbers.
7.
Enter the serial number, which matches the serial number seen on the product
label, or a number that was designated for use by the competent national
authority.
8.
Tap
“
Done
”
when finished.
9.
Tap “ENTER” button on Program screen
. The 32-digit hex code is shown at the
bottom of the screen, with the abbreviated 15-digit hex code below it.
10.
For the ELT 345s or ELT 1000s only:
tap
“Program”; quickly place ELT switch
in the test mode and release. (Quickly is <1 second).
11.
Tap the “Program” button to program the ELT
.
12.
Ensure that screen shows “Programming
Successful”.
13.
Verify ELT u
sing “Sarcalc
, as described in Subsection 6.2.
4.8
Programming a Different Country Code for use with a Specific 24-Bit
Address
1.
Follow the instructions for the 24-bit address method being used (short or long).
Refer to Subsection 4.7.3, 4.7.4, or 4.7.10, as appropriate.
2.
After “Enter” button function
is used, go to the top of the screen and tap
on “Artex
ELT Programmer bar”
.
3.
Tap
on “Options”
.
4.
Select: “Defaults”
.
5.
Tap
in “Country” entry space and go to numbers selection on
Graffiti screen.
6.
Enter required country code.
7.
Tap
“
Done
”
when finished.
8.
Tap
“
R
eturn”
on the Override default screen.
9.
Tap
“Program”
on the Programmer screen.
10.
After programming successful, launch Sarcalc and verify programmed information,
as described in Subsection 6.2.
