MATXM-CORE-411-WR-Quick Start Guide
Artesyn Embedded Technologies
Marketing Communications
2900 S. Diablo Way, Suite 190
Tempe, Arizona 85282
Artesyn Embedded Technologies
Lilienthalstr. 17-19
85579 Neubiberg/Munich
Germany
Install the processor
cooler
1. Take the processor cooler and the back-
plate out of the antistatic package and
check for damages.
2. Take off the protective film from the
backplate to reveal the glue layer.
3. Align the backplate onto the mother-
board. The screw holes on the backplate
should fit exactly into the holes on the
motherboard.
Note: Make sure that the glue layer of the
backplate does not touch any other part
of the motherboard.
4. Place the cooler on the backplate
by screwing it on.
5.
Connect the fan to the motherboard
.
5
Install the memory mod-
ule
1. Lay the MATXM-CORE-411-B where
the module is to be installed on the antistatic
desktop.
2. Take the SODDIM out of the antistatic pack-
age, holding it by the edges.
3. Line up the notch located on the row of the
metal pins at the bottom of the module with
the key in the SODIMM slot on
the motherboard.
4. Insert the SODIMM in a slantwise position or
at a 45-degree angle to slide the module into
place.
5. Press down on the module against the moth-
erboard until you hear it snap into place. The
modules must be properly aligned before you
press it down into its final position. You can
remove the module from the socket and rein-
stall it if you cannot easily press it down into
its final position.
6
Do
not
touch the memory chips when han-
dling the module.
Do
not
press on the memory chips when you
push it into its final position.
Do
not
touch the metal pins.
The MATXM-CORE-411-B (target) requires
two connections to the host computer – a
serial connection for the console output,
and an Ethernet connection for communi-
cation between the target and the Wind
River Workbench Development tools.
Perform the following procedure to con-
nect the target and host computer:
1. Ensure that your host computer is
switched off.
2. Connect the 9-pin serial cable between
the COM1 socket of the motherboard
MATXM-CORE- 411-B and the primary
serial port on your host machine.
3. Connect an Ethernet cable between the
Ethernet port on the motherboard
MATXM-CORE-411-B and the primary
Ethernet port on your host computer.
This can either be a direct connection or
through a hub or switch. Note that the
evaluation host and motherboard
MATXM-CORE-411-B will be assigned
pre-configured static IP addresses during
the evaluation.
7
Connecting the Target and
Your Host Computer
