INSPECTION
You will want to inspect your spa, prior to filling it up with water. Look for
and remove any debris in the spa tub and in the filter. Verify that pump
plugs are installed on the pumps and the pump unions are tight.
FILLING THE SPA WITH WATER
NOTE: DO NOT fill your spa with hot water straight out of your water
heater or tap. This water may be as hot as 180º F and will cause dam-
age to the surface and plumbing of the spa. This will void your warranty.
Level the spa before filling.
1) Prepare to fill the tub by removing all debris.
2) Remove the filters from your spa (see Removing, Installing and
Cleaning Filters, page 19)
3) Insert the hose in the area where the filter was located as shown in
the picture below.
4) Fill the spa to the bottom of the pillows or about 6-8 inches from the
top of the spa Note: DO NOT OVER-FILL YOUR TUB!
5) With the front panel off, verify there are no leaks at the pump union.
Note: Pump unions can become loose during shipping. Verify that there
are no leaks during filling of the spa.
13
