Page 11
Remotely Control Scan Do® SD
Remotely Control Scan Do® SD
Text Commands
Example of a
Successful Storage Procedure
Example of a
Failed Storage Procedure
Save Text Procedure
The procedure for a save text command is as follows:
1) The remote controller sends the storage command with the string to store
and the number of characters in the string.
2) The Scan Do SD puts the remote port in “text” mode and sends out a ready
message where it repeats the command, the string number and the number
of characters in the string.
3) The remote controller receives the ready message and then sends
the string. The string can contain any ASCII character including a carriage
return.
4) The Scan Do SD counts the number of characters specified in the initial
storage command and if the incoming characters equal the number of
characters specified in the initial storage command, the Scan Do SD stores
the string in EEPROM, padding any characters left out of the 128 maximum
with the Hex value of 0xff.
5) The Scan Do SD sends an acknowledgement to the remote controller and
puts the remote port back into regular command mode.
Sent From:
Protocol:
Remote Controller
su:2,37
Scan Do SD
su:2=37
Remote Controller
Configured by Joe Cool, June 29, 2007
Scan Do
>
Sent From:
Protocol:
Remote Controller
su:2,37
Scan Do SD
su:2=37
Remote Controller
Configured by
Scan Do
(after 5 seconds)
E10 >
