Artel InfinityLink IL6000, Инструкция по установке и эксплуатации

Страница: 23 / 35

10 IL6000 Chassis Installation and Operations Manual
IL6000 Chassis
Flush-Mounting the Chassis
Artel ships the chassis with the mounting brackets installed for flush-mounting the unit as shown in
Figure 5 .
1. To flush-mount the IL6000 in an equipment rack, perform the following steps:
2. Raise the unit to the appropriate installation height.
3. Align the screw holes on the mounting brackets with the screw holes on the equipment rack.
4. Install the screws through the chassis mounting brackets into the threaded screw holes on the rack. The
chassis requires two screws for each side of the chassis (mounting screws not included).
Figure 5. Flush-Mounted Chassis Bracket
Mounting the Chassis to a Wall
To install the IL6000 as a wall-mounted unit, perform the following steps:
1. Remove the three screws that secure each of the mounting brackets to the side of the chassis.
2. Rotate the mounting brackets to the desired wall-mounting position (example shown in Figure 6 ).
3. Secure the mounting brackets to the chassis using the screws that you removed in Step 1.
4. Secure the chassis to the wall with four mounting screws (mounting screws not included).